Car Inflator Pump Cigarette Lighter Charger Head Wiring Diagram179

Introduction:

Car inflator pumps are essential tools for keeping your tires inflated and ensuring a safe and comfortable driving experience. They are powered by your car's battery, and typically connect to the cigarette lighter socket. The charging head is a critical component that ensures the pump receives the necessary power to operate effectively. In this article, we will provide a comprehensive guide to installing the charging head of your car inflator pump.

Materials Required:
Car inflator pump
Charging head
Wires (red, black, and yellow)
Wire connectors
Electrical tape

Step 1: Safety First

Before starting the installation, ensure your car is parked and the engine is turned off. Disconnect the negative battery terminal to prevent any electrical accidents.

Step 2: Locate the Cigarette Lighter Socket

Identify the cigarette lighter socket in your vehicle. It is typically located on the dashboard or center console.

Step 3: Prepare the Charging Head

The charging head has three wires: red (positive), black (negative), and yellow (signal). Cut the wires to the desired length, ensuring that there is enough length to reach the cigarette lighter socket and the inflator pump.

Step 4: Connect the Wires

Connect the red wire from the charging head to the positive terminal of the cigarette lighter socket. Similarly, connect the black wire to the negative terminal. The yellow wire should be connected to the signal terminal, which may be labeled "S" or "IG."

Step 5: Secure the Connections

Use wire connectors to secure the connections. Ensure the connections are tight and insulated properly with electrical tape.

Step 6: Connect the Inflator Pump

Connect the inflator pump to the charging head by inserting the plug into the corresponding socket.

Step 7: Test the Connection

Reconnect the negative battery terminal and start your car. Turn on the inflator pump and check if it operates correctly.

Step 8: Finalize the Installation

Once you have confirmed that the inflator pump is functioning properly, secure any loose wires or connectors with electrical tape for a neat and professional finish.

Tips:
Use heat shrink tubing to further insulate the connections for increased durability.
Label the wires with colored tape or markers to prevent confusion during installation.
If you encounter any difficulties during the installation, consult with a qualified mechanic or electrician.

Conclusion:

Installing the charging head of your car inflator pump is a straightforward process that can be completed in a short amount of time. By following the steps outlined in this article, you can ensure that your inflator pump is properly connected and ready to use whenever you need it.

2025-01-14

Previous：Is It Worth Getting an Onboard Air Compressor?

Next：Understanding the Growing Popularity of Custom Car Covers