Carbuster Foam Cannon Leaking at Nozzle135

If you're experiencing leakage from the nozzle of your Carbuster foam cannon, it can be a frustrating issue to deal with. Not only does it waste water and soap, but it can also make your car wash experience less enjoyable. Fortunately, there are a few simple steps you can take to fix the leak and get your foam cannon working like new again.

Check the Nozzle O-ring

The most common cause of a leaking nozzle is a damaged or worn O-ring. O-rings are small rubber rings that create a seal between the nozzle and the cannon body. If the O-ring is damaged, it can allow water and soap to leak out. To check the O-ring, simply remove the nozzle from the cannon and inspect it for any signs of damage. If the O-ring is damaged, you will need to replace it with a new one.

Tighten the Nozzle

Another possible cause of a leaking nozzle is that it is not tightened properly. To tighten the nozzle, simply turn it clockwise until it is snug. Be careful not to overtighten the nozzle, as this can damage the threads.

Inspect the Hose and Fittings

If you have checked the nozzle and O-ring and the leak is still persisting, it is possible that the leak is coming from the hose or fittings. To check the hose, simply disconnect it from the cannon and inspect it for any cracks or leaks. If the hose is damaged, you will need to replace it with a new one. To check the fittings, simply tighten them using a wrench.

Clean the Nozzle

If the leak is coming from the nozzle itself, it is possible that the nozzle is clogged with dirt or debris. To clean the nozzle, simply remove it from the cannon and soak it in a solution of hot water and vinegar. After soaking the nozzle for a few minutes, use a small brush to clean out any dirt or debris. Once the nozzle is clean, rinse it off with water and reattach it to the cannon.

Contact Customer Support

If you have tried all of the above steps and the leak is still persisting, it is possible that there is a more serious problem with your foam cannon. In this case, you should contact Carbuster customer support for assistance.

Here are some additional tips to help prevent your foam cannon from leaking:

Use the correct nozzle for your foam cannon. Different nozzles have different flow rates, so using the wrong nozzle can cause the cannon to leak.
Do not overtighten the nozzle. Overtightening the nozzle can damage the threads and cause the cannon to leak.
Inspect the hose and fittings regularly for any signs of damage. If you find any damage, replace the hose or fittings immediately.
Clean the nozzle regularly to prevent it from becoming clogged with dirt or debris.
Store the foam cannon in a cool, dry place when not in use.

2025-01-31

---

Previous：The Linkon and Thules - Car Inflator You Can Trust

Next：Car Diffuser for Jaguar: An Aromatic Oasis on the Road