How to Disassemble a Skyworth Amplifier19

Materials:
Phillips head screwdriver
Flat head screwdriver
Plastic spudger

Instructions:
Remove the back panel. Use a Phillips head screwdriver to remove the four screws holding the back panel in place. Carefully lift the back panel off the amplifier.
Disconnect the power supply. Locate the power supply connector on the back of the amplifier and disconnect it.
Remove the heat sink. Use a Phillips head screwdriver to remove the four screws holding the heat sink in place. Carefully lift the heat sink off the amplifier.
Remove the output transistors. Use a flat head screwdriver to gently pry the output transistors out of their sockets.
Remove the input transistors. Use a flat head screwdriver to gently pry the input transistors out of their sockets.
Remove the capacitors. Use a plastic spudger to gently pry the capacitors off the amplifier board.
Remove the resistors. Use a plastic spudger to gently pry the resistors off the amplifier board.
Remove the diodes. Use a plastic spudger to gently pry the diodes off the amplifier board.
Remove the volume knob. Use a flat head screwdriver to gently pry the volume knob off the amplifier front panel.
Remove the front panel. Use a Phillips head screwdriver to remove the four screws holding the front panel in place. Carefully lift the front panel off the amplifier.
Remove the amplifier board. Use a Phillips head screwdriver to remove the four screws holding the amplifier board in place. Carefully lift the amplifier board off the chassis.

The amplifier is now disassembled.

2025-01-06

Previous：Electric Shaver Rash: Causes, Prevention, and Treatment

Next：Screwdriver Set Tensile Strength