How to Re-wick a VGOD Trick Tank324

The VGOD Trick Tank is a popular sub-ohm tank that is known for its excellent flavor and cloud production. However, like all tanks, the Trick Tank will eventually need to be re-wicked. Re-wicking your tank is a simple process that can be done in a few minutes. Here is a step-by-step guide on how to re-wick a VGOD Trick Tank:

Materials you will need:* New cotton wick (VGOD sells a 10-pack of pre-cut wicks that are specifically designed for the Trick Tank)
* Tweezers
* Scissors

Instructions:1. Disassemble the tank. To do this, unscrew the top cap, remove the coil head, and then unscrew the base of the tank.
2. Remove the old wick. Use the tweezers to gently pull the old wick out of the coil head. Be careful not to damage the coil head.
3. Cut a new wick. Cut a piece of cotton wick that is about 6 inches long.
4. Thread the wick through the coil head. Start by threading the wick through the bottom hole of the coil head. Then, pull the wick through the top hole.
5. Trim the wick. Trim the wick so that it is about 1/2 inch long on either side of the coil head.
6. Fluff the wick. Use the tweezers to gently fluff the wick. This will help to increase the surface area of the wick and improve the flavor and cloud production.
7. Reassemble the tank. Screw the base of the tank back on, then insert the coil head and screw on the top cap.
8. Prime the tank. To prime the tank, fill it with e-liquid and then take a few puffs without firing the device. This will help to saturate the wick with e-liquid.

Tips:* For best results, use a cotton wick that is specifically designed for the VGOD Trick Tank.
* If you are having trouble threading the wick through the coil head, you can use a pair of tweezers to help you.
* Be sure to trim the wick so that it is not too long. If the wick is too long, it can cause the tank to flood.
* After you have re-wicked your tank, it is important to prime it before using it. This will help to prevent the tank from burning the wick.

Re-wicking your VGOD Trick Tank is a simple process that can be done in a few minutes. By following these steps, you can keep your tank performing at its best.

2025-02-02

Previous：The Ultimate Guide to Finding the Best Nail Clippers

Next：Sphygmomanometers: Essential Instruments for Blood Pressure Measurement