How to Coil the Typhoon GT3 RTA163

Introduction

The Typhoon GT3 RTA is a popular rebuildable tank atomizer known for its excellent flavor and cloud production. Coiling the GT3 is a straightforward process, but it's important to do it correctly to avoid any potential problems. In this guide, we'll show you how to coil the Typhoon GT3 RTA step-by-step.

Tools and Materials Needed

Before you start, you'll need the following tools and materials:- Typhoon GT3 RTA
- Wire (24-28 gauge recommended)
- Cotton
- Scissors
- Flush cutters
- Wire cutters
- Screwdriver

Step 1: Prepare the Coil

Cut a piece of wire to your desired length. The recommended length is 5-6 wraps, but you can adjust this to your liking. Use a wire cutter to cut the wire, and then use a flush cutter to trim the ends flush.

Step 2: Wind the Coil

Wrap the wire around the included coil jig 5-6 times. Make sure the wraps are tight and even. Once the coil is wound, remove it from the jig.

Step 3: Position the Coil

Place the coil in the build deck of the GT3. Use a screwdriver to tighten the screws holding the coil in place. Make sure the coil is centered and level.

Step 4: Trim the Excess Wire

Use wire cutters to trim the excess wire from the leads of the coil. Leave about 2mm of wire on each lead.

Step 5: Dry Burn the Coil

With the GT3 still dry, fire the coil on your mod at a low wattage. Gradually increase the wattage until the coil glows evenly from the center to the outside. This will help to remove any impurities from the coil.

Step 6: Wick the Coil

Cut a piece of cotton to the desired length. The length of the cotton will depend on the size of your coil and the juice well of the GT3. Fluff up the cotton and insert it into the coil. Make sure the cotton is not too tightly packed, as this can restrict airflow and affect flavor.

Step 7: Trim the Excess Cotton

Use scissors to trim the excess cotton from the ends of the coil. Make sure the cotton is flush with the top of the build deck.

Step 8: Reassemble the GT3

Reassemble the GT3 by placing the top cap back on the base. Screw on the airflow control ring and fill the tank with e-liquid.

Step 9: Prime the Coil

Before vaping, prime the coil by dripping a few drops of e-liquid directly onto the cotton. This will help to saturate the cotton and ensure that the coil is properly primed.

Step 10: Enjoy!

Once the coil is primed, you're ready to start vaping. Enjoy the great flavor and cloud production of the Typhoon GT3 RTA!

Troubleshooting

If you're having any problems with your Typhoon GT3 RTA, here are a few troubleshooting tips:- No vapor production: Check to make sure that the coil is properly wicked and that the leads are not touching each other.
- Weak flavor: Try using a higher-quality wire or a thicker gauge wire. You can also experiment with different wicking materials.
- Leaking: Make sure that the O-rings are properly seated and that the tank is assembled correctly.
- Burnt taste: The coil may be dry. Try priming the coil or using a higher-quality e-liquid.

Conclusion

Coiling the Typhoon GT3 RTA is a simple process that can be done in just a few minutes. By following these instructions, you can ensure that your GT3 is performing at its best and producing great flavor and cloud production.

2025-02-07

Previous：When To Use Baby Nail Clippers vs. Baby Nail Scissors

Next：Identifying Real from Fake Aloe Vera Acne-Clearing Cleansers